Remote Control Commands
R&S
®
SMBV100A
622Operating Manual 1176.8016.02 ─ 17
Parameters:
<Frequency> float
Value range depends on the max bandwidth, see data sheet
Range: -40E6 to 40E6
*RST: 0
Example:
BB:ARB:MCAR:CARR:MODE ARB
Activates ARB multi-carrier mode.
BB:ARB:MCAR:CARR:FREQ 5.0
Sets 5.0 MHz carrier frequency.
Manual operation: See " Carrier Freq [MHz] " on page 435
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:PHASe <Phase>
The command sets the start phase of the selected carrier.
The phase settings are only valid if optimization of the crest factor is disabled
(:SOURce:BB:ARB:MCARrier:CFACtor:MODE OFF).
Parameters:
<Phase> float
Range: 0 to 359.99
Increment: 0.01
*RST: 0
Default unit: DEG
Example:
BB:ARB:MCAR:CARR15:PHAS 90 DEG
sets a start phase of 90° for carrier 15.
Manual operation: See " Phase " on page 435
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:POWer <Power>
The command sets the gain of the selected carrier.
Parameters:
<Power> float
Range: -80 to 0
Increment: 0.01
*RST: 0
Default unit: dB
Example:
BB:ARB:MCAR:CARR15:POW -50 dB
sets the power of carrier 15 to -50 dB.
Manual operation: See " Gain " on page 435
[:SOURce<hw>]:BB:ARBitrary:MCARrier:POWer:REFerence <Reference>
Defines the way the individual carriers in a composed multi carrier signal are leveled.
SOURce Subsystem
To Next Page
Loading...
