Instrument Function
R&S
®
SMBV100A
435Operating Manual 1176.8016.02 ─ 17
State ← Carrier Table
Switches On/Off a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:STATe on page 623
Carrier Freq [MHz] ← Carrier Table
Sets the carrier frequency.
Note: The carrier frequnecy can only be set in "Arbitrary Carrier frequency" mode.
For "Equidistant Carrier Spacing", the carrier spacing is determined automatically.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FREQuency
on page 621
Gain ← Carrier Table
Sets the gain of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:POWer on page 622
Phase ← Carrier Table
Sets the starting phase of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:PHASe on page 622
Delay ← Carrier Table
Sets the starting delay of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:DELay on page 621
File ← Carrier Table
Calls the "File" menu for selecting the input file with the I/Q signal to be modulated onto
the carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FILE on page 621
Info ← Carrier Table
Indicates the sample rate, number of I/Q value pairs (number of samples), and the
resulting signal period of the selected I/Q input file.
Remote command:
n.a.
!!! ← Carrier Table
Indicates an occurred conflict by a means of a red LED. A conflict arises when the car-
riers overlap.
Baseband Signal - Baseband Block
To Next Page
Loading...
