Instrument Function
R&S
®
SMBV100A
447Operating Manual 1176.8016.02 ─ 17
"On"
Corresponds to the default state of this parameter.
The signal calculation starts simultaneously with the external trigger
event but because of the instrument’s processing time the first sam-
ples are cut off and no signal is outputted. After elapsing of the inter-
nal processing time, the output signal is synchronous to the trigger
event.
"Off"
The signal output begins after elapsing of the processing time and
starts with sample 0, i.e. the complete signal is outputted.
This mode is recommended for triggering of short signal sequences
with signal duration comparable with the processing time of the
instrument.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut
on page 704
Trigger Delay
Delays the trigger event of the signal from:
●
The external trigger source
Use this setting to:
●
Synchronize the instrument with the device under test (DUT) or other external devi-
ces
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay on page 706
Baseband Signal - Baseband Block
To Next Page
Loading...
