Rohde & Schwarz SMBV100A - Page 463

Instrument Function
R&S
®
SMBV100A
448Operating Manual 1176.8016.02 ─ 17
Trigger Inhibit
Available on external triggering.
Sets the duration for inhibiting a new trigger event subsequent to triggering.
In the "Retrigger" mode, every trigger signal causes signal generation to restart. This
restart is inhibited for the specified duration.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit on page 707
Marker Mode
Provides the settings necessary to define the marker output signal for synchronizing
external instruments.
Marker Mode
Marker configuration for up to 4 marker channels. The settings are used to select the
marker mode defining the shape and periodicity of the markers. The contents of the
dialog change with the selected marker mode; the settings are self-explanatory.
All regular marker signals are described in "Marker Modes" on page 336.
"Restart"
A marker signal is generated at the start of the waveform.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE on page 710
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider on page 712
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 712
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern on page 711
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime on page 711
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime on page 711
Marker Delay
The delay of the signals on the MARKER outputs is set in the"Marker Delay" section.
The R&S SMBV supports only two markers.
Marker x Delay
Enters the delay between the marker signal at the marker outputs and the start of the
frame or slot.
The input is expressed as a number of symbols. If the setting "Fix marker delay to
dynamic range" is enabled, the setting range is restricted to the dynamic range. In this
range the delay of the marker signals can be set without restarting the marker and sig-
nal.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay on page 709
Current Range without Recalculation
Displays the dynamic range within which the delay of the marker signals can be set
without restarting the marker and signal.
The delay can be defined by moving the setting mark.
Baseband Signal - Baseband Block