Instrument Function
R&S
®
SMBV100A
449Operating Manual 1176.8016.02 ─ 17
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MINimum?
on page 710
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MAXimum?
on page 709
Fix marker delay to current range
Restricts the marker delay setting range to the dynamic range. In this range the delay
can be set without restarting the marker and signal.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut:DELay:FIXed on page 709
Clock Settings
The Clock Settings is used to set the clock source and a delay if required.
Sync. Mode
Selects the synchronization mode.
This parameter is used to enable generation of very precise synchronous signal of sev-
eral connected R&S SMBVs.
Note: If several instruments are connected, the connecting cables from the master
instrument to the slave one and between each two consecutive slave instruments must
have the same length and type.
Avoid unnecessary cable length and branching points.
"None"
The instrument is working in stand-alone mode.
"Sync. Master"
The instrument provides all connected instrument with its synchroni-
sation (including the trigger signal) and reference clock signal.
"Sync. Slave"
The instrument receives the synchronisation and reference clock sig-
nal from another instrument working in a master mode.
Remote command:
[:SOURce<hw>]:BB:MCCW:CLOCk:SYNChronization:MODE on page 714
Set Synchronization Settings
Performs automatically adjustment of the instrument's settings required for the syn-
chronization mode, selected with the parameter "Synchronization Mode".
Remote command:
[:SOURce<hw>]:BB:MCCW:CLOCk:SYNChronization:EXECute on page 715
Clock Source
Selects the clock source.
"Internal"
The internal clock reference is used to generate the symbol clock.
Baseband Signal - Baseband Block
To Next Page
Loading...
