Remote Control Commands
R&S
®
SMBV100A
709Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern............................................. 711
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider.................................... 712
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?............................712
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut:DELay:FIXed <Fixed>
Restricts the marker delay setting range to the dynamic range. In this range the delay
can be set without restarting the marker and signal. If a delay is entered in setting ON
but is outside this range, the maximum possible delay is set and an error message is
generated.
The numeric suffix in OUTPut has no significance for this command, since the setting
always affects every marker.
Parameters:
<Fixed> 0 | 1 | OFF | ON
*RST: 0
Example:
BB:MCCW:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
Manual operation: See "Fix marker delay to current range" on page 449
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay <Delay>
Sets the delay between the signal on the marker outputs and the start of the signals,
expressed in terms of samples. Command :BB:MCCW:TRIGger:OUTPut:DELay:
FIXed ON can be used to restrict the range of values to the dynamic range, i.e. the
range within which a delay of the marker signals can be set without restarting the
marker and signal.
Parameters:
<Delay> float
Range: 0 to 16777215
Increment: 0.001
*RST: 0
Example:
BB:MCCW:TRIG:OUTP2:DEL 16
sets a delay of 16 samples for the signal on connector MARKER
2.
Manual operation: See "Marker x Delay" on page 448
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MAXimum?
Queries the maximum marker delay for setting :BB:MCCW:TRIGger:OUTPut:
DELay:FIXed ON.
SOURce Subsystem
To Next Page
Loading...
