Rohde & Schwarz SMBV100A - Page 723

Remote Control Commands
R&S
®
SMBV100A
708Operating Manual 1176.8016.02 ─ 17
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
AUTO
The multi carrier signal is generated continuously.
RETRigger
The multi carrier signal is generated continuously. A trigger
event (internal or external) causes a restart.
AAUTo
The multi carrier signal is generated only when a trigger event
occurs. After the trigger event the signal is generated continu-
ously. Signal generation is stopped with command
SOURBB:MCCW:TRIG:ARM:EXEC and started again when a trig-
ger event occurs.
ARETrigger
The multi carrier signal is generated only when a trigger event
occurs. The device automatically toggles to RETRIG mode.
Every subsequent trigger event causes a restart. Signal genera-
tion is stopped with command SOURBB:MCCW:TRIG:ARM:EXEC
and started again when a trigger event occurs.
SINGle
The multi carrier signal is output only when a trigger event
occurs. After the trigger event the signal is output once to the set
sequence length (SOURBB:MCCW:TRIG:SLEN). Every subse-
quent trigger event causes a restart.
*RST:
AUTO
Example:
BB:MCCW:SEQ AAUT
sets the "Armed_auto" trigger mode; the device waits for the first
trigger (e.g. with *TRG) and then generates the signal continu-
ously.
Manual operation: See "Trigger Mode" on page 444
Marker Settings
This section lists the remote control commands, necessary to configure the markers.
The marker delay settings are available for R&S SMx and R&S AMU instruments only.
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut:DELay:FIXed.............................................. 709
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay.................................................709
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MAXimum?...............................709
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MINimum?................................ 710
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE.................................................710
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime.............................................711
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime.............................................. 711
SOURce Subsystem