Instrument Function
R&S
®
SMBV100A
458Operating Manual 1176.8016.02 ─ 17
The complex I/Q bandwidth of the shifted useful signal must not exceed the total avail-
able baseband bandwidth (see data sheet).
The setting range of the frequency offset is then calculated as described in "Frequency
Offset" on page 324. With R&S SMBV-K522 for example, it is ±80 MHz.
Remote command:
[:SOURce<hw>]:BBIN:FOFFset on page 718
Phase Offset
Enters the phase offset for the external baseband signal.
The offset affects the signal on the output of the "Baseband In/Out" block.
Remote command:
n.a.
External Baseband Signal - Baseband Input
To Next Page
Loading...
