Rohde & Schwarz SMBV100A - Page 546

Remote Control Commands
R&S
®
SMBV100A
531Operating Manual 1176.8016.02 ─ 17
Figure 7-9: Representation in the C-List Editor
Example: C-List ASCII File
C-List in ASCII format, corresponding to C-List editor Figure 7-9:
{TYPE:SMU-CL}{COPYRIGHT:2003 Rohde&Schwarz SMU}{DATE:2011-07-19;14:58:44}
{HOP LIST:0:0;498:1;506:0}{CW MODE LIST:0:0;380:1}{LEVATT LIST 1:0:0;464:1}
{BURST LIST:0:0;122:1;270:0;582:1;924:0}
{MARKER LIST 4:0:0;706:1;764:0}{MARKER LIST 3:0:0;530:1;633:0}
{MARKER LIST 2:0:0;350:1;457:0}{MARKER LIST 1:0:0;108:1;160:0}
{CONTROL LENGTH:1000}
The tags to the traces in the C-List editor are:
●
HOP LIST
●
CW MODE LIST
●
LEVATT LIST 1
●
BURST LIST
●
MARKER LIST 4
●
MARKER LIST 3
●
MARKER LIST 2
●
MARKER LIST 1
●
CONTROL LENGTH
CONTROL LENGTH defines the periodicity of the total C-List. The remaining tags
define the individual markers or control traces in a combined state/starting time way
within the C-List period.
If you want to write an ASCII C-List directly without using the C-List editor, a special
syntax has to be taken into account:
●
The tag and the following [state: start time]-pairs are separated by a colon ":".
Waveform and List Format