Rohde & Schwarz SMBV100A - Page 649

Remote Control Commands
R&S
®
SMBV100A
634Operating Manual 1176.8016.02 ─ 17
Example:
MMEM:CDIR '/var/user/waveform'
sets the default directory.
BB:ARB:WAV:CAT?
reads out all the files in the default directory.
Response: sin1, wave
the directory contains the waveform files sin1.wv and
wave.wv.
Usage: Query only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:CATalog:LENGth?
Reads out the files in the default directory and returns the number of waveform files in
this directory. The default directory is set using command MMEM:CDIRectory. Only
files with the file extension *.wv will be listed.
Return values:
<Length> integer
Number of waveform files in default directory
Range: 0 to INT_MAX
*RST: 0
Example:
MMEM:CDIR '/var/user/waveform'
sets the default directory.
BB:ARB:WAV:CAT?
reads out all the files in the default directory.
Response: sin1, wave
the directory contains the waveform files sin1.wv and
wave.wv.
BB:ARB:WAV:CAT:LEN?
Response: 2
Usage: Query only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:CLOCk <Filename>, <Clock>
Appends information on the ARB clock rate to specified waveform file. The file must
contain I/Q and/or marker data and have been created with the command :MMEMory:
DATA:UNPRotected on page 570.
Parameters:
<Filename> string
Complete file path and file name with file extension (*.wv).
If the file is in the default directory, the file path can be omitted.
Setting parameters:
<Clock> float
Range: 400 to 100E6
Increment: 1E-3
*RST: 1E6
SOURce Subsystem