SATO CL4NX Plus - Page 239

239
[Paper End]
Select the sensor for sensing the paper end.
The options are as follows:
Using I-mark
Use the I-mark sensor (reflective type) to detect the paper end.
Using Gap
Use the Gap sensor (transmissive type) to detect the paper end.
[Head Base Position]
Set the position used for the base reference point for printing.
The options are as follows:
Item CL4NX Plus
[Standard] Print with a standard base reference point.
[Left-justify] Move the base reference point 2 mm (0.08") to the left
toward the product.