SATO CL4NX Plus - Page 424

[SDPL]
424
[Module Selection]
Set whether to prioritize the settings that are done through the product or through commands for the
module selection setting.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings that are done through the product.
• Even if you select [Commands], the settings that are done through the product are
used if no command is sent.
[Format Attribute]
Set the format attribute.
You can change this setting if you have selected [Settings] in the [Prioritize] > [Format Attribute] menu.
The options are as follows:
• [XOR]