SATO CL4NX Plus - Page 712

712
Error Message 1013 (USB R/W Error)
When there is an error with the product, the error message appears on the screen.
Check the cause and countermeasure, and then take appropriate action.
To clear the error:
Connect the USB memory and then disconnect it, or press the button (OFFLINE) or the
button.
Cause and Countermeasure
Cause (1)
The USB memory is disconnected while writing.
Countermeasure (1)
Connect the USB memory.
Cause (2)
The copy area in the USB memory is not sufficient.
Countermeasure (2)
Make sure that the USB memory has sufficient copy area.
Cause (3)
Writing to the USB memory fails.
Countermeasure (3)
Replace the USB memory.
Cause (4)
The USB memory is not formatted.
Countermeasure (4)
Format the USB memory to a FAT32 format.
Contact your SATO technical support center if the error cannot be resolved.