SATO LP 100R - Uneven Image Density

LP 100R Laser Printer Operator's Guide Chapter 5: Problem Solving
Rev: 1 Page 5-16 April, 2014
of 30 pages
Uneven Image Density
Checking item Result Remedy
1 Is the form damp? Yes Replace
2 Is the developing unit correctly set? No Correct the setting
3 Is the OPC cartridge correctly set? No Correct the setting
Note: When the label form is printed, paste may come out (and stick to the label
form surface). This glue may be transferred to the drum, causing an image noise.
 Discard documents on which glue has accumulated.
 If an image noise occurs, clean the cleaner blade.