LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-77 April, 2014
of 128 pages
Characters Per Inch
The Characters Per Inch setting specifies the character width and horizontal
spacing to be used by the printer. Increasing the number of characters to be
printed per inch causes a corresponding decrease in character width.
Note: The Characters Per Inch setting can not be changed when a print job is in
progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Characters Per Inch function.
2. Press Enter, which causes the following Characters Per Inch screen to display:
Figure 6-59. Characters Per Inch screen.
Note:
• Pressing CL after entering numeric data deletes 1 digit each time it is pressed.
• The number of characters per inch can be expressed only in Text Characters.
Current
number of
characters
per inch
To Next Page
Loading...
