SATO LP 100R - Vertical Adjustment; When a Print Job Is in Progress

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-79 April, 2014
of 128 pages
Vertical Adjustment
The Vertical Adjustment setting specifies the distance from the top of the form to
the top of the print area in either inches, mm, 7200/inch, scan lines, or DPI (dots
per inch) as defined by the Unit Field.
Note:
 The Vertical Adjustment setting can be changed when either a print job is in
progress or the printer is idle.
 If the Vertical Adjustment is changed, the software automatically stores the
change negating the need to execute the Store function.
When a Print Job Is in Progress
1. Press the OFFLINE switch, which causes the following Offline Print menu to
display:
Figure 6-60. Offline Print menu.
Note: The system has switched from the Online Print mode to the Offline Print
mode.