LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-31 April, 2014
of 128 pages
Job Trace Enable/Disable
When Job Trace is enabled, whatever print job goes into the printer’s print
server will be archived into a directory that is File Transfer Protocol (FTP)
accessible.
When the Job Trace is disabled, print jobs going into the printer’s print server
will not be saved in the FTP folder.
Windows Network Printing – Enable/Disable
When Windows Network Printing is enabled, data can be printed through
Windows.
When Windows Network Printing is disabled, data cannot be printed through
Windows.
Raw Printing (TCP/IP Setup)
Port – A port is a predefined internal address that serves as a pathway from
the application to the transport layer or from the transport layer to the
application.
Timeout – The predefined length of wait time between the end of the first job
and the start of the second job, before a determination is made that there are
no more jobs in the print queue, causes a timeout to occur.
Configuration Function
This function allows you to recall a previously created configuration, store a new
configuration (using a numeric identifier), remove an existing configuration (by
removing the identifier without removing the configuration), or edit the currently
active configuration.
The Edit option in the Configuration function provides access to all printer
configuration elements (via the Printer Setup menu). By editing the currently
active configuration, you can create a new configuration and (if desired) save it as
a new stored configuration.
For detailed information on the Configuration function, see
Configuration Procedures on page 6-57.
To Next Page
Loading...
