SATO LP 100R - AIDC Mode

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-127 April, 2014
of 128 pages
AIDC Mode
The AIDC Mode permits adjustment of the image.
Note: The AIDC Mode setting can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the AIDC Mode function.
2. Press Enter, which causes the following AIDC Mode screen to display:
Figure 6-88. AIDC Mode screen.
Note:
• Brackets ( [ ] ) around a specific AIDC Mode setting indicate that it is the
Default AIDC Mode setting.
• An arrow () pointing to a specific AIDC Mode setting indicates that it is
the setting assigned to the current configuration.