LP 100R Laser Printer Operator's Guide Chapter 3: Printer Operation
Rev: 1 Page 3-10 April, 2014
of 32 pages
System Start-up Procedures
1. If the POWER LED is not illuminated, press the POWER LED switch to power
up the printer. (See Figure 3-2.)
2. If no paper stock has been loaded into the printer, the audible alarm sounds,
and the following screen displays:
Figure 3-6. No paper stock loaded – BEEP button shown.
3. Press the BEEP button once to turn off the audible alarm, and see the
document loading procedures starting on page 3-30.
4. If stock has been loaded into the printer, the controller will cycle through its
self-test, load the system software, print fonts, logos, default configuration
data, and cause the system start-up screen shown on page 3-11 to display.
To Next Page
Loading...
