LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-14 April, 2014
of 128 pages
Font Sampler
The Font Sampler page shows the name of each active font stored on the printer,
including all base printer fonts and all user-installed PostScript and TrueType fonts
stored in the active font directory. The page also shows the index number used by
the LP 100R to track each font (on the left edge of the printout) and a sample of
the font (on the right side of the printout).
Note: The Font Sampler can not be printed when a print job is in progress.
1. Press the Up or Down triangle on the Test Prints menu to move the selection
bar to the Font Sampler function.
2. Press Enter, which causes the following screen to display while the Font
Sampler is printing:
Figure 6-8. Font Sampler screen.
3. To terminate printing, press Clear.
4. Printing is terminated, and the system returns to the Supervisor Menu.
5. Press Feed until the printed form completely ejects from the printer.
To Next Page
Loading...
