LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-118 April, 2014
of 128 pages
Reverse Mode
The Reverse setting, when Enabled, feeds blank forms ejected from the printer at
the end of a print job back into the printer to minimize wasting unprinted tag/label
stock. Some forms are constructed such that they are not able to be fed back into
the printer.
The Reverse Mode, when Enabled, takes longer to start and stop, which adds
overall time and reduces the effective throughput.
Note: The Reverse setting can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Reverse function.
2. Press Enter, which causes the following Reverse Mode screen to display:
Figure 6-84. Reverse Mode screen.
To Next Page
Loading...
