SATO LP 100R - Horizontal Adjustment; When a Print Job Is in Progress

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-83 April, 2014
of 128 pages
Horizontal Adjustment
The Horizontal Adjustment setting specifies the distance from the left edge of the
document to the start of the print area either in inches, mm, 7200/inch, or DPI as
defined by the Unit field.
Note:
 The Horizontal Adjustment setting can be changed when either a print job is in
progress or the printer is idle.
 If the Horizontal Adjustment is changed, the software automatically stores the
change, negating the need to execute the Store function.
When a Print Job Is in Progress
1. Press the OFFLINE switch, which causes the following Offline Print menu to
display:
Figure 6-64. Offline Print menu.
Note: The System switched from the Online Print mode to the Offline Print mode.