SATO LP 100R - Touch Display Unit

LP 100R Laser Printer Operator's Guide Chapter 4: Printer Maintenance
Rev: 1 Page 4-13 April, 2014
of 24 pages
Touch Display Unit
The TDU display on the LP 100R shows status, warning, or error messages when a
printer component needs to be replaced. Figure 4-2 shows a status message.
Figure 4-2. Control panel display for a status message.
Error messages indicate that the printer cannot operate until a component is
replaced and will cause the printer to stop and the audible alarm to sound. Press
the BEEP button to turn off the audible alarm.
Warning messages inform you of the need to change consumables based on the
number of pages run on the particular consumable. There are two levels of
warnings:
 When 90% of the life of a consumable has been reached, the printer displays
the message Near End of Life. This is to let you know that the item needs to be
replaced in a short time.
 When the full life of the item has been reached, the printer displays the
message End of Life, which indicates that the item should be replaced as soon
as possible. Continuing to use the printer with this consumable may
compromise print quality. (See Figure 4-3 for an example.)
Status
message