SATO LP 100R - Power down Procedures; Emergency Power down; Normal Power down

LP 100R Laser Printer Operator's Guide Chapter 3: Printer Operation
Rev: 1 Page 3-6 April, 2014
of 32 pages
Power Down Procedures
Normal Power Down
1. Press the Off button (Soft Power switch) to initiate the power down cycle. See
Figure 3-3.
2. When the Are you sure? prompt appears, do one of the following:
 If you wish to proceed with powering down, press the Enter button in the
lower-right corner of the display.
The power down cycle continues with the orderly shutdown of the printer.
 If you do not wish to continue, press the Back button. This displays the
previous screen.
Figure 3-5. Powering down the printer.
Emergency Power Down
In case of an emergency there are two alternative methods to power down the
printer.
 Press the Emergency Power switch on the left side of the printer cabinet. (See
Figure 2-1 in Chapter 2.) This switch will immediately remove power from the
printer and the controller.
OR
 Press and hold the POWER LED switch for at least 20 seconds.
Important Note: Neither of these methods allows for an orderly shutdown of the
devices. These methods should only be used in an emergency situation.