LP 100R Laser Printer Operator's Guide Chapter 5: Problem Solving
Rev: 1 Page 5-18 April, 2014
of 30 pages
Error Messages Requiring Operator Intervention
When displayed, the printer error messages listed below will require operator
intervention.
Code Message Suggested Action
AIH
AIL
AHO
ALO
AIDC High
AIDC Low
AIDC High (Out of Table)
AIDC Low (Out of Table
Clean AIDC sensor (see page 4-7).
Check or replace:
- Charger unit (see page 4-5)
- Developer unit
- OPC cartridge (see page 4-18)
ATH
ATL
ATDC High
ATDC Low
Check or replace developer unit.
BUE Burster Error Clear forms from burster and exit roller
area (see page 5-7).
DUE Developer Error Check or replace developer unit.
FME Form End Load an additional supply of forms.
FMU Form Unloaded Load new forms into the printer.
IFS Illegal Form Size Check page length setting.
Note: When the swing guide is used, the
page length cannot be less than 10" or
more than 12".
ILK1 EP Holder Interlock Close EP drawer.
ILK2 Tractor Interlock Close tractor unit.
ILK3 Fuser Interlock Close fuser unit.
ILK4 Left Cover Interlock Close left side door.
ILK5 Front Cover Interlock Close front door.
JAM1 Separator Jam Clear jam in EP drawer.
JAM2 Fuser Jam Clear jam in fuser unit.
JAM3 Stacker Jam Clear jam in stacker unit.
JAM4 Tractor Jam Clear jam in tractor unit.
JAM5 Exit Roller Area Jam Clear jam in exit roller area.
Continued on next page
To Next Page
Loading...
