SATO LP 100R - Emulation

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-93 April, 2014
of 128 pages
Emulation
The Emulation setting is the interpretation of the commands contained in the data
stream received by the Data Communication Port.
Note: The Emulation setting can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Emulation function.
2. Press Enter, which causes the following Emulation screen to display:
Figure 6-71. Emulation screen.
3. The following functions can be selected from the Emulation screen:
 Kodescript
 Hex Dump
 Line Printer
 KodescriptPlus
 HP PCL5e
 IBM 5256
 IGP/PGL
 IGP/VGL
 IPDS (optional)