SATO LP 100R - Introduction

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-4 April, 2014
of 128 pages
Introduction
This chapter explains the Supervisor Menu, which is used to create the parameters
in the printer's configuration.
The printer uses fonts, logos, and formats created externally and then stored on
the printer’s hard drive. The print data, which includes information about the fonts,
logos, and page format to be used, is sent to the LP 100R from a host computer.
Configuration parameters, however, must be set in the TDU prior to initiating a
print job.