SATO LP 100R - Horizontal Fine Adjustment Menu Buttons; Modify Horizontal Fine Adjustment

LP 100R Laser Printer Operator's Guide Chapter 3: Printer Operation
Rev: 1 Page 3-20 April, 2014
of 32 pages
Modify Horizontal Fine Adjustment
The Modify Horizontal Fine Adjustment function, which specifies the distance from
the left side of the document to the start of the print area, is accessed either by
selecting Horizontal Fine Adjustment from the Print Alignment menu or by
selecting Horizontal Fine Adj. from the Operator Express menu.
Selecting this function from either menu causes the following screen to display:
Figure 3-13. Modify Horizontal Fine Adjustment.
Horizontal Fine Adjustment Menu Buttons
Button Function
Home Press Home to return the system to the Exit Menu System
screen.
Back 1. Press Back to return the system to the Exit Menu System
screen if this function was accessed from that screen.
2. If this function was accessed from the Operator Express
menu, press Back to return the system to the Main menu.
1. Press Up to select a higher value or Press Down to select a lower value.
Note:
 You can also enter the desired value on the numeric keypad.
 To enter a negative value, enter the value and then press the Minus (-)
key.
2. Press Enter, to store the new setting and return the system to the Operator
Express menu.
Current
horizontal
adjustment