SATO LP 100R - Network Time Enable (Select Server Time)

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-54 April, 2014
of 128 pages
Network Time Enable (Select Server Time)
This permits changing the Server Time IP address if Server Time will be used.
1. Press the Up or Down triangle on the Network Time Setting menu to move
the selection bar to the Network Time Enable function.
2. Press Enter, which causes the following screen to display:
Figure 6-43. Network Time Enable menu.
3. Press the Up or Down triangle on the Network Time Enable menu to move the
selection bar to the Enabled function.
4. Press Enter, which selects the Server Time as the time to be used.
5. A Synchronization Successful message displays, and the system returns to the
Network Time Setting menu.