LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-66 April, 2014
of 128 pages
Remove Configuration
The Remove setting lets you remove a configuration.
Note: A stored Print Configuration can not be removed when a print job is in
progress.
1. Press the Up or Down triangle on the Configuration menu to move the
selection bar to the Remove function.
2. Press Enter, which causes the following Remove Config screen to display:
Figure 6-53. Remove Config screen.
3. Select the Configuration number to be deleted by either pressing the Up
and/or Down triangle or by entering the number on the numeric keypad.
Note: The Default Configuration (000) can not be deleted.
To Next Page
Loading...
