LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-10 April, 2014
of 128 pages
1
/
10
” Grid
The
1
/
10
" Grid test pattern is a printout of a graph paper pattern of 0.1" squares
using the current form size. This test page allows you to evaluate the print quality,
verify the form size, and check the horizontal and vertical alignment for the
current configuration.
Note:
1
/
10
" Grid patterns can not be printed when a print job is in progress.
1. Press the Up or Down triangle on the Test Prints menu to move the selection
bar to the
1
/
10
" Grid function.
2. Press Enter, which causes the following screen to display while the Grid is
printing:
Figure 6-4.
1
/
10
” Grid test pattern.
3. To terminate printing, press Clear, which causes a Cancelling Test Print
message to display.
4. When printing is terminated, the system returns to the Supervisor Menu.
5. Press Feed until the printed form completely ejects from the printer.
To Next Page
Loading...
