SATO LP 100R - Set Time

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-46 April, 2014
of 128 pages
Set Time
This allows you to change the System Time to either an earlier or later time.
1. Press the Up or Down triangle on the Supervisor Menu to move the selection
bar to the Up-Time function.
2. Press Enter, which causes the following Time menu to display:
Figure 6-34. Time menu.
3. Press the Up or Down triangle to move the selection bar to the Set Time
function.
4. Press Enter, which causes the following screen to display:
Figure 6-35. Set Time.