LP 100R Laser Printer Operator's Guide Chapter 5: Problem Solving
Rev: 1 Page 5-17 April, 2014
of 30 pages
Warning Messages
Warning messages are displayed when specified maintenance functions are to be
executed by either the printer operator or a SATO service representative.
In most cases the printer will continue to run after displaying one of the following
messages. To delay taking the suggested action, however, may cause some
degradation of the print quality.
Message Suggested action
200K PM – Schedule
Maintenance
Call service to schedule maintenance (200,000 pages
have been run).
400K PM – Schedule
Maintenance
Call service to schedule maintenance (400,000 pages
have been run).
800K PM – Schedule
maintenance
Call service to schedule maintenance (800,000 pages
have been run).
Cleaning Blade End of
Life
Replace the cleaning blade (see page 4-21).
Cleaning Blade Near
End of Life
Cleaning blade has a limited number of pages left.
Make preparations to replace the unit.
Developer Unit End of
Life
If a “prepped” standby developer unit is available:
a. Remove the old unit from the printer.
b. Install the new developer unit in the printer.
If a “prepped” standby developer unit is not
available, call service to schedule maintenance.
Developer Unit Near
End of Life
Developer unit has a limited number of pages left.
Make preparations to replace the unit.
Starter End of Life 1. If a “prepped” standby developer unit is available,
remove the old unit from the printer and retain it
for the SATO service representative.
2. Insert the replacement developer unit in the
printer.
Starter End of Life
(Developer Powder)
If a "prepped" standby developer unit is not available,
call service to schedule maintenance.
Starter Near End of
Life
Starter has a limited number of pages left. Make
preparations to replace the unit.
Toner Near Empty Replace the toner bottle (see page 4-15).
Waste Toner Collecting
Bottle Near Full
Replace the waste toner collecting bottle
(see page 4-17).
To Next Page
Loading...
