LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-61 April, 2014
of 128 pages
Recall Configuration
The Recall function is used to load a stored configuration into the printer. Once
loaded, the configuration can be used to print the related documents, or it can be
modified for subsequent use.
Note: A stored Print Configuration cannot be recalled when a print job is in
progress.
1. Press the Up or Down triangle on the Configuration menu to move the
selection bar to the Recall function.
2. Press Enter.
3. The following screen displays:
Figure 6-49. Recall Configuration screen.
4. If the current configuration is to be recalled, press Enter.
5. To select a different configuration, you can either:
Press the Up or Down triangle to move the selection bar to the desired
configuration, and then press Enter
to load it.
or
Enter the desired configuration number on the numeric keypad, and then
press Enter, which will load it.
Current
Config
To Next Page
Loading...
