SATO LP 100R - Copying the System Error Log

LP 100R Laser Printer Operator's Guide Appendix B: Managing Files
Rev: 1 Page B-54 April, 2014
of 60 pages
Copying the System Error Log
1. If the POWER LED is not green, press it for approximately 1 second and
release.
2. When the System Start-up screen displays, press the OFFLINE switch to
change the printer from the Online Idle mode to the Offline Idle mode.
3. Press Menu to display the Main Menu.
4. Select Advanced from the Main Menu and press Enter.
5. Select Supervisor from the Advanced Menu and press Enter.
Note: If access to the software is password protected, an Enter Password
prompt displays. See page 6-39 for the rules governing password protection.
6. Select Files from the Supervisor Menu and press Enter.
7. The following screen displays:
Figure B-51. Files System Error Log selected.