SATO LP 100R - Active to USB

LP 100R Laser Printer Operator's Guide Appendix B: Managing Files
Rev: 1 Page B-11 April, 2014
of 60 pages
Active To USB
1. Select Active To USB from the Fonts menu and press Enter.
2. The following screen displays:
Figure B-7. Copy Font To USB selected.
3. Using the Up and Down buttons, select each font to be copied to a flash drive,
pressing Select after each font selected.
Note: When Enter is pressed, an asterisk (*) displays to the left of the font
selected.
4. If any font that has been selected is not to be copied:
a. Reselect the font.
b. Press Select.
c. The asterisk (*) is erased, and the font is not copied to the flash drive.