SATO LP 100R - Emulation Errors; Kodescript Errors

LP 100R Laser Printer Operator's Guide Chapter 5: Problem Solving
Rev: 1 Page 5-23 April, 2014
of 30 pages
Emulation Errors
Kodescript™ Errors
Code Description Explanation
F1 Not in Kodescript
Mode
The printer controller received data before receiving
the Kodescript on (^PY^-) command. This error
will clear when the (^PY^-) command is received.
F2 Unknown
Command
The printer controller has received data that it
cannot interpret as a Kodescript command.
F3 Unsupported
Command
The printer controller has received data that it
cannot interpret as a Kodescript command.
F4 Communications
Buffer Overflow
The printer’s communications buffer has
overflowed, usually due to incorrect flow control
between host and printer.
F5 Too Many Fields The Kodescript program has too many fields in it.
F6 Illegal Conversion An incorrect hex conversion of a high-level ASCII
character is present.
FC Too Many
Characters in a
Field
When using the (^f01^-) command, the number
of data characters in a field must not exceed the
maximum number of characters specified for that
field.
FE Wrong Number of
Data Fields
The number of data fields in the program does not
match the number of data fields in the Repeat
command.