SATO LP 100R - Ethernet Setup

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-28 April, 2014
of 128 pages
Ethernet Setup
Note: The Ethernet settings can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Interface Setup menu to move the
selection bar to the Ethernet function.
2. Press Enter, which causes the following Ethernet Setup menu to display:
Figure 6-20. Ethernet Setup menu.
3. The functions that can be selected from this menu include:
 Enable Ethernet
 Host Protocol
 Static IP Settings
 DHCP IP Settings
 Activate New Settings
 Job Trace
 Windows Network Printing
 Raw Printing