LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-101 April, 2014
of 128 pages
Line Termination
The Line Termination setting specifies how the printer should interpret the end-of-
line characters included in the print data it receives. This setting affects the printer
only when the Line Printer or PCL5e Emulation is used.
Note: The Line Termination setting can not be changed when a print job is in
progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Line Termination function.
2. Press Enter, which causes the following Line Termination Screen to display:
Figure 6-75. Line Termination screen.
Note:
• Brackets ( [ ] ) around a specific Line Termination indicate that it is the Default
Configuration Line Termination setting.
• An arrow () pointing to a specific Line Termination indicates that it is the
Line Termination setting assigned to the currently displayed configuration.
To Next Page
Loading...
