LP 100R Laser Printer Operator's Guide Appendix A: Installing System Software
Rev: 1 Page A-3 April, 2014
of 10 pages
System Program – Full Installation
Note: Before installing a full system, it is important that you print a Status page
and the Configuration pages of the current file, which can be used as a backup
reference to the current file.
See Chapter 3: Printer Operation for the procedures relevant to printing Status
and Configuration pages.
1. Verify that the POWER LED switch is illuminated in green.
2. Open the front door on the printer.
NOTE: Opening the front door causes the audible alarm to sound, and a Front
Cover Interlock graphic error message displays.
3. Press the BEEP button to turn off the alarm.
4. Insert the USB Flash Drive into the USB port.
5. Close the front door on the printer.
6. Reboot the system.
To Next Page
Loading...
