SATO LP 100R - Network Time Setting Function; Network Time Setting Function Access

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-52 April, 2014
of 128 pages
Network Time Setting Function
The Network Time Setting function defines whether the METO-Logic Controller is to
use the Local System Time, or whether it is to synchronize the time with a Time
Server.
Note: Network Time Settings can not be changed when a print job is in progress.
Network Time Setting Function Access
1. Press the Up or Down triangle when the Supervisor Menu displays to move
the selection bar to the Network Time Setting function.
2. Press Enter, which causes the following Network Time Setting menu to
display:
Figure 6-41. Network Time Setting menu.
3. The functions that can be selected from the Network Time Setting Menu
include:
• Net Time Enable – Specifies whether or not the Local System Time will
be used.
• Time Server – Permits changing the Server Time IP address if Server
Time will be used.