SATO LP 100R - Network Time Enable (Select Local System Time)

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-53 April, 2014
of 128 pages
Network Time Enable (Select Local System Time)
This allows you to specify whether or not the Local System Time will be used.
1. Press the Up or Down triangle on the Network Time Setting menu to move
the selection bar to the Net Time Enable function.
2. Press Enter, which causes the following screen to display:
Figure 6-42. Network Time Enable menu.
3. Press the Up or Down triangle on the Network Time Enable menu to move the
selection bar to the Disabled function.
4. Press Enter, which selects the Local System Time as the time to be used, and
return the system to the Network Time menu.