LP 100R Laser Printer Operator's Guide Chapter 5: Problem Solving
Rev: 1 Page 5-20 April, 2014
of 30 pages
Printer Hardware Messages
Some printer hardware problems may require entering a call for service.
If this becomes necessary, be prepared to supply the applicable error code to the
SATO service contact when making the call.
Code Message Suggested action
BSH Bias Short
DMM Developer Motor
Malfunction
EFM Exhaust Fan
Malfunction
ELM Eraser Lamp
Malfunction
FCH Flash Charging Error
FHT Fuser High
Temperature
FPM Flash Motor Malfunction
Cycle power to the printer (by pressing and
holding down the POWER LED switch for
20 seconds) and retry. If the problem
persists, call service.
IFE Interface Error
MCS Main Charger Short
MFL Mis-Flash
OFM Ozone Fan Malfunction
PDM OPC Drive Motor
Malfunction
PMM P/H Motor Malfunction
PSM Phase Sensor
Malfunction
Continued on next page
To Next Page
Loading...
