SATO LP 100R - Supervisor Responsibilities; Appendix A: Installing System Software; Appendix B: Managing Files

LP 100R Laser Printer Operator's Guide Chapter 3: Printer Operation
Rev: 1 Page 3-8 April, 2014
of 32 pages
Supervisor Responsibilities
The supervisor is directly responsible for the creation and/or maintenance of the
configurations stored on the hard drive of the controller. These include:
 Test Prints
 Interface Setup
 Configuration (Recall, Store, Remove, Edit)
 Files
 Password Enable/Change
 Time
Procedures relative to all of the above, excluding Files, are included in
Chapter 6: Supervisory Functions.
The Files procedures are included in the following appendices.
Appendix A: Installing System Software
This appendix explains how to install the operating software for the LP 100R and
how to copy and/or install the various files used by the printer to control printer
operations, including the following:
 System Program
 System Menu
 User's Configurations
 System Setup
Appendix B: Managing Files
This appendix discusses the following:
 System Error Log
 Capture
It also explains how to store fonts, logos, and formats on the controller's hard
drive in either of the following directories:
 Active directory (one for each type of file) – which contains the files that are
available to an application when the printer is started
 Archive directory (one for each type of file) – which contains files that are not
available
Once stored on the hard drive, files can be:
 Moved back and forth between the active and archive directories
 Copied from the printer's diskette drive to either directory
 Deleted from either directory
 Note: If password protection has been enabled, none of the direct
responsibilities attributed to the supervisor can be accessed until the correct
password is entered.