SATO LP 100R - Reset Function; Reset Function Access

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-33 April, 2014
of 128 pages
Reset Function
This option resets the printer and the METO-Logic Controller.
Note: The Reset menu has been included in this section only as a point of
reference. Its use is limited to service personnel when troubleshooting a potential
printer problem.
Reset Function Access
1. When the Supervisor Menu displays, press either the Up or Down triangle to
move the selection bar to the Reset function.
2. Press Enter, which causes the following menu to display:
Figure 6-22. Reset menu.
3. The functions that can be selected from the Reset menu include:
 Reset METO-Logic
 Reset Engine
 Reset All
 Reset Defaults