LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-30 April, 2014
of 128 pages
Host Protocol
Static Routing – Requires the network administrator to manually enter the
Static IP routing information including the Static IP Address, Subnet Mask, and
Gateway Address.
Dynamic Host Configuration Protocol (DHCP) – Enables computers to
receive TCP/IP configurations automatically. The DHCP IP address can be
stored only. It cannot be changed.
BootP (Boot Prom) – The BootP Protocol, which starts as the computer is
powered on, loads an operating system into the computer by reading it from a
network server instead of a local disk drive. The operating system located on
the server is pre-built for a specific IP address.
Activate New Settings
If a change is made to any of the options indicated below, the Activate New
Settings option must be executed for the change or changes to be recognized:
Enable/Disable Ethernet
Host Protocol
Static IP Settings
To Next Page
Loading...
