LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-39 April, 2014
of 128 pages
Password Enable Function
The Password Enable function allows you to either initiate or terminate password
protection.
If password protection is enabled, access to the Supervisor Menu is inhibited until
a valid password is entered.
Password Enable Function Access
1. Press the Up or Down triangle on the Supervisor Menu to move the selection
bar to the Password Enable function.
2. Press Enter, which causes the following Password Enable screen to display:
Figure 6-27. Password Enable menu.
Note:
Brackets ( [ ] ) around either Disabled or Enabled indicate that it is the default
configuration password status.
An arrow () pointing to either Enabled or Disabled indicates the status
assigned to the current configuration.
To Next Page
Loading...
