SATO LP 100R - Form Height

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-71 April, 2014
of 128 pages
Form Height
The Form Height setting specifies, in inches, the height of the document to be
printed.
Note: The Form Height setting can not be changed when a print job is in
progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Form Height function.
2. Press Enter, which causes the following Form Height screen to display:
Figure 6-56. Form Height.
Note:
 Pressing UN permits changing the units and all associated numeric data to
any one of the following:
- inches
- mm
- 7200/inch
- Scan lines
- Dots 1/400
 Pressing CL after entering numeric data deletes 1 digit each time pressed.
3. The form height can be either increased or decreased in 0.1667" increments,
from a minimum of 5.0000" to a maximum of 24.0000".
Current
height