SATO LP 100R - Emergency Power Switch; Fuser Unit; Burster Unit (Optional Component); Side Panel Switches

LP 100R Laser Printer Operator’s Guide Chapter 2: Printer Components
Rev: 1 Page 2-6 April, 2014
of 12 pages
Emergency Power Switch
Powers the printer down in emergency conditions.
Fuser Unit
 Houses the fuser lamp, fuser filter, and associated fans.
 In the fuser unit, the fuser lamp flashes at fixed time intervals, which causes
the lamp to fuse the toner on printed documents.
 The suction feed belts and exit rollers, located beneath the fuser unit, move
the printed forms past the fuser unit, out of the printer, and onto the stacker
table.
Burster Unit (Optional Component)
See Top Panel Switch LED Functions.
Side Panel Switches
Are identical to top panel switches.
METO-Logic Controller
 Interprets data from the host computer, translating it to the image in which it
is to be printed, and then controls the Print function via the switches and TDU.
 Supports the following emulations:
 KodescriptPlus™
 Kodescript™
 HP
®
PCL5e
®
 IPDS Emulations (3816, 4028, MODI)
 Generic Line Printer
 Hex Dump Mode
 IGP/VGL
 IGP/PGL
 Supports the following communications ports:
 RS-232 (for service use only)
 Centronics parallel
 Ethernet
 Stores user’s fonts, logos, and formats, which are loaded and subsequently
retrieved via USB flash drive.
 Displays, via the TDU, relevant messages such as printer status, periodic
maintenance requirements, and error messages.
 Includes software diagnostics for service support.