SATO LP 100R - Waste Toner Collecting Bottle Replacement

LP 100R Laser Printer Operator's Guide Chapter 4: Printer Maintenance
Rev: 1 Page 4-17 April, 2014
of 24 pages
Waste Toner Collecting Bottle Replacement
When the waste toner collecting bottle becomes full, replace it by means of the
following procedure:
1. Open the front door.
2. Remove the waste toner collecting bottle and tighten the cap so as not to spill
the toner inside.
3. Remove the sealing cap from its storage position on the waste toner collecting
bottle.
4. Snap the cap over the bottle opening making certain that it is securely
fastened.
5. Install the new toner collecting bottle.
6. Close the front door.
7. Discard the tightly sealed waste toner collecting bottle.
Waste toner collecting bottle